Assembly - Columbus McKinnon Yale CPV Series Translated Operating Instructions

The load must not be moved into areas which are not visible to the operator. If necessary, he must seek help.
The following are applicable to devices in a trolley:
The longitudinal downward slope of the carriageway must not exceed 0,3 %.
The adjustment of the trolley width must not be extended in order to e. g. obtain a smaller radius curvature.
Any modification of the lifting device is prohibited. A unit modified without consulting the manufacturer must not be used.
Never attach the load to the tip of the hook. The load must always be seated in the saddle of the hook. This also applies to the
suspension hook.
Do not throw the hoist or trolley down. Always place it properly on the ground.
Never reach into moving parts.
Only one load lifting attachment may be suspended in the load hook of the hoist.
The unit must not be operated in potentially explosive atmospheres.
A
SSEMBLY
Assembly and maintenance of the device is to be entrusted only to persons who are trained in the field in question and have been
commissioned by the owner to assemble and service the device.
These persons must know the common accident prevention rules, e.g. "Winches, lifting and hoisting devices (BGV D8)", "Cranes –
power driven winches (EN14492-1)" etc., and must be appropriately trained. They should also be familiar with the operating and
installation instructions drafted by the manufacturer.
NOTE: If the unit is operated in the open, it must be appropriately protected against adverse weather conditions (e.g. by roofing).
Inspection Before Assembly
Check for transport damage
Check for completeness
Check that the capacity indication on hoist and bottom block match.
Electric Chain Hoist With Suspension Bracket (Standard version)
In a single thread operation, the suspension bracket is integrated with the long latch side to the right, and in double-thread operation
with the long latch side to the left.
ATTENTION: Do not forget the locking washers following installation of the latch.
The supporting structure must be dimensioned in such a way that the total operating forces can be safely absorbed.
Electric Chain Hoist With Trolley
The devices are delivered as pre-installed and are designed for the beam range A or B specified on the ratings plate. Before installing
the chain hoist, make sure that the width of the track beam is within the adjustment range of the delivered trolley (see Tab. 1).
1/1
Flange width
Beam range
[mm]
min.
A 58
B 180
Tab. 1
©
2016 Columbus McKinnon Industrial Products GmbH
2/1
Flange thickness
[mm]
max. max.
180 27
300 27
26