Transport, Storage, Decommissioning And Disposal - Columbus McKinnon Yale CPV Series Translated Operating Instructions

39
T , S , D D
RANSPORT TORAGE ECOMMISSIONING AND ISPOSAL
Observe the following for transporting the unit:
• Do not drop or throw the unit, always deposit it carefully.
• Load and hand chains (only for models with reel trolley) must be transported in such a way that knotting and formation of loops are
avoided.
• Do not bend control switch cables and power supply cables.
• Use suitable transport means. These depend on the local conditions.
Observe the following for storing or temporarily taking the unit out of service:
• Store the unit at a clean and dry place where there is no frost.
• Protect the unit (including all attached parts) against contamination, humidity and damage by means of a suitable cover.
• Protect hooks against corrosion.
• A light lubricant film should be applied to the chain(s).
• Do not bend control switch cables and power supply cables.
• In the case of models with an integral trolley, grease the load bar as well as both threaded rods to protect them against corrosion.
If the unit is to be used again after it has been taken out of service, it must first be inspected again by a competent person.
D :
ISPOSAL
After taking the unit out of service, recycle or dispose of the parts of the unit in accordance with the legal regulations.
Further information and operating instructions for download can be found at www.cmco.eu!
©
2016 Columbus McKinnon Industrial Products GmbH