Siemens SINAMICS S120 Equipment Manual page 120

Active line modules with cold plate
5.5 Installing the Cold-Plate Modules on Customer-Specific Heat Sinks
Installation
Figure 5-5 Installing a cold-plate power section with an external heat sink and heat-conducting film
To begin, tighten the screws by hand (approx. 0.5 Nm) in the sequence shown (steps 1 to 4)
and then secure them (10 Nm).
Help with the mechanical cabinet design is available from:
Siemens AG
A&D SE WKC
CoC CabinetCooling
P.O. Box 1124
09070 Chemnitz, Germany
E-mail: cc.cabinetcooling@siemens.com
120
Booksize cold-plate power units
Manual, (GH4), 03.2007, 6SL3097-2AJ00-0BP4