Table of Contents
Advertisement
Industrial Electronic Devices
SET COMMUNICATION:
This section define the fundamental communication parameters of two buses, Modbus
TCP and EtherNet/IP.
By Pressing the
"Set
Communication" button from the main window for SW67665
(Fig. 2) the window "Set Communication" appears (Fig. 3).
The means of the fields for "Modbus TCP Slave" are:
In the fields
"IP
ADDRESS" the IP address for Modbus TCP side of the converter
is defined;
In the fields
"SUBNET
converter is defined;
In the fields "GATEWAY" the default gateway of the net is defined. This feature
can be enabled or disabled pressing the Check Box field. This feature is used for
going out of the net;
In the field "Port" the port used for Modbus TCP communication is defined.
If the field
"Read with Input Register / Status
possible to read the Input bytes of EtherNet/IP side with Input Registers
(Function 04) and write the Output bytes of EtherNet/IP side with Holding
Registers (Function 06/16). The Output bytes are readable with Function 03.
Otherwise, only Holding Registers will be used and the Output bytes of
EtherNet/IP side cannot be read back.
ADFweb.com Srl – IT31010 – Mareno – Treviso
Mask" the SubNet Mask for Modbus TCP side of the
Function" is checked, it is
User Manual EtherNet/IP Master / Modbus TCP Slave
Document code: MN67665_ENG
Figure 3: "Set Communication" window
INFO:
www.adfweb.com
Revision 1.000
Page 15 of 25
Phone +39.0438.30.91.31
Advertisement
Table of Contents
