Using Fillit Pc Software; Using Internal Software; Dispensing Parameters; Plate Type - Thermo Scientific Multidrop Combi nL User Manual

Routine Operation
Using FILLit PC
software
Using internal
software
Dispensing
parameters
34
Thermo Scientific Multidrop Combi nL User Manual
The operation of the Multidrop Combi nL dispenser can also be
controlled by an external computer and run on FILLit Software for
Multidrop Combi nL. In addition to the Multidrop Combi nL internal
software features, you can use multistep protocols, that is, protocols
with several steps (e.g. Dispense, Shake, Empty, etc.), and create new
calibrations for new liquids. The user can also download to the
instrument protocols with one dispense step and an additional shake
step or transfer protocols from one instrument to another. Calibrations
can also be transferred to the internal software.
Use FILLit Software to enter the valve correction factors while changing
the spare valve.
For more information, refer to the FILLit Software for Multidrop Combi
nL User Manual (Cat. no. N17562).
This section describes procedures related to the Multidrop Combi nL
internal software.
This section describes the relevant dispensing parameters required to
create and edit a protocol. All these parameters are set in the Main
menu.
Note Make the plate type selection first because all the other
parameters are dependent on the plate type.
Caution Make sure the plate lid (if used) is removed before
dispensing.

Plate type

Go to the Main menu.
Press
s
.
OK
s
Thermo Fisher Scientific