Table 4-3. Default Parameter Values For Different Plate Types - Thermo Scientific Multidrop Combi nL User Manual

Thermo Fisher Scientific
Select the plate type using the Up and Down arrow keys.
Press to accept the selection.
OK
The available plate types and the default parameter values are given in
Table 4–3. Each plate type has a selected default maximum dispensing
volume and dispensing height, which is automatically set by the
instrument.
Table 4–3. Default parameter values for different plate types
Plate type
96-well standard (15 mm)
96-well low DW (deep well) (22 mm)
384-well low volume (7.5 mm)
384-well low profile (10 mm)
384-well standard (15 mm)
384-well DW (22 mm)
1536-well low volume (5 mm)
1536-well standard (10.5 mm)
* You can dispense without warning to the maximum dispensing volume, but once the maximum is
exceeded, a warning appears and you have to press
** The default dispensing height is 1 mm above the selected plate.
Note If the default plate values do not agree with yours, change the
dispensing offset and height values in the Settings menu. You can save
the plate values for future use.
Note You can also select more plates or define new plates with FILLit
Software and download them to the instrument, if needed.
Max.
dispensing
volume * (µl)
500
600
25
70
130
200
2
13
to continue dispensing.
OK
s
Thermo Scientific Multidrop Combi nL User Manual
Routine Operation
Dispensing parameters
Dispensing
height (mm) **
16
23
8.5
11
16
23
6
11.5
s
35