Installing The Priming Vessel; Installing The Pressure/Vacuum System Reservoir; Figure 3-7. Transport Lock Storage; Figure 3-8. Inserting The Priming Vessel - Thermo Scientific Multidrop Combi nL User Manual

Installation
Installation setups
Installing the
priming vessel
Installing the
pressure/vacuum
system reservoir
20
Thermo Scientific Multidrop Combi nL User Manual
3. After that fasten the
the dispenser with the same screws for storage (Figure 3–7). Keep
the transport lock there until needed for future relocation or
transportation of the instrument.
Figure 3–7. Transport lock storage
To install the priming vessel:
1. Insert the priming vessel (Cat. no. N07271) into its slot on the
blue
left of the plate carrier by pressing it over a snap lock (Figure 3–8).
Figure 3–8. Inserting the priming vessel
2. Insert a priming vessel tube assembly or cap (Cat. no. N05843) into
the drain of the priming vessel or a vessel underneath the drain.
To install the pressure/vacuum system reservoir, that is, the reagent
reservoir:
transport lock piece to the back panel of
red
Thermo Fisher Scientific