Watkins-Johnson Company WJ-8718-19/FE Instruction Manual page 63

INSTALLATION AND OPERATION WJ-8718-19/FE HF RECEIVER
2.4.7.4 Special Function Display
2.4.7.5 Erase Memory
Entering 10* on the keypad erases the contents of all memory channels,
including the quick access channel, and then performs a RESET sequence. The RESET
sequence leaves the receiver in local mode.
2.4.8 REMOTE OPERATION VIA RS-232 SERIAL INTERFACE
The RS-232 Option permits full control of receiver parameters by an
external controller. To establish remote operation, the operator must depress the
front panel REMOTE keypad.
2.4.8.1 Preparation For Operation
Prior to remote operation via RS-232, the receiver must be place in the
remote operating mode and remote operating parameters must be established in the
I/O board and switches.
2.4.8.1.1 Remote Operating Mode
A receiver to be addressed as a listener must be placed in the remote
operating mode by depressing the front panel REMOTE keypad. The receiver can be
addressed to talk regardless of the receiver operating mode. Local or remote
operating mode cannot be established by remote command.
2-38