Watkins-Johnson Company WJ-8718-19/FE Instruction Manual page 56

Example 22:
[1] [7]
[RCL]
i n u m b L f i n u n r\iMJ urCIXrt I IUN
Initiate a Sector A scan utilizing the receiver register parameters
stored with the sector's fl frequency in memory channel 17.
(1) Data entry; "17" displayed in
FREQUENCY/MHZ display window.
(2) Termination command; receiver
parameters set to those stored in
channel 17; "17" displayed in MEM
ADRS display window.
[AUTO SCAN]
(3) Termination command; receiver
scans Sector A; "17" remains
displayed in MEM ADRS display
window.
Example 23:
[1] [8]
[RCL]
Initiate a Sector A scan utilizing the receiver register parameters
stored with the sector's f2 frequency in memory channel 18.
(1) Data entry; "18" displayed in
FREQUENCY/MHZ display window.
(2) Termination command; receiver
parameters set to those stored in
channel 18; "18" displayed in MEM
ADRS display window.
(3) Termination command; receiver
scans Sector A; "18" displayed in
MEM ADRS display.
[AUTO SCAN]
Comments: In either of the above examples, it is not necessary to enter "17"
on the keypad before pressing AUTO SCAN. Pressing AUTO
SCAN without entering keypad data beforehand, and with "17" or
"18" displayed in the MEM ADRS display window, automatically
initiates a Sector A scan. Likewise, pressing AUTO SCAN, with
a "19" or "20" displayed automatically initiates a Sector B scan.
2.4.6.3.3 Sector Scan/Receiver Register Data Source - Memory Channel
The receiver register data stored in any of the 100 memory channels may
be utilized to set the receiver parameters prior to initiating a sector scan. The
following procedure recalls receiver register data from any memory channel and
initiates a sector scan. Example 24 shows a typical command sequence.
2-31