GILES GBF Series Operation & Service Manual page 83

Fryer Operation
5.04 Filtering Used Cooking Oil - continued
12. After the vat has refilled, return Selector Switch
position and immediately turn the Oil Return Valve handle
the [CLOSE] position.
13. Check oil level in the vat; add if below FULL level.
Oil Return Valve must remain in the [CLOSE] position except when
filtering. Failure to do so can allow oil to siphon back to the Filter
Pan, causing a low oil condition in the vat.
Always wear thermal protection when performing this step. Parts can be excessively hot!
14. After refilling vat, remove Filter Pan from unit (see Step #3). Use the provided Crumb Shovel
care not damage or puncture the filter media, scoop filter sediment from its surface and dispose. It is not
essential that filter media be refreshed after each filter cycle, but it is recommended to clean the Filter Pan and
refresh media at least every day (see Section 6.03).
15. Reinstall Filter Pan under unit.
16. To continue cooking, see Section 5.03, Cooking Procedure.
To discontinue cooking, see Section 5.05, Normal Shut-Down.
NOTE!
FILTER REMINDER (Computer Control units) - when FORCE FILTER is not set to [ON], the Controller still displays
a filter reminder at the completion of every cook cycle after FILTER COUNT is exceeded. The message "PLEASE
FILTER OIL" will be displayed on the Upper Display. Press the [START] key to continue cooking if filtering
cannot be performed at the time.
⑧
to the [OFF]
⑨
back to
GBF Ventless Electric Fryer
GBF-35D & 50D-VH
8
⑩
and taking
10
9
71