GILES GBF Series Operation & Service Manual page 31

Overview
3.02.2 Control Panel - Manual Controls
Item Description
1 Power Switch
2 Selector Switch
Digital Temperature
3
Control (Thermostat)
4 Cook Timer (ea. Basket)
5 Power Indicator Light (Green)
6 Heat Indicator Light (Amber)
7 High-Limit Indicator (Red)
8 Drain Open Indicator (Red)
9 Filter Missing Indicator (Red)
10 Cycle End Indicator (Amber)
11 Alarm Reset Button
12 Fire Extinguisher Manual Pull Handle
13 EAC Status [ON]
14 EAC Status [WASH/CHECK]
Push to Start
15*
Button (ILS Only)
* ILS Manual Control Model Only
Function
Main Power Switch ... turns Fryer power ON or OFF.
Selector Switch ... 3-position switch to select operation mode ...
[COOK-OFF-PUMP]. Heating elements only operate when in the
[COOK] position. The switch is placed in the [PUMP] position to run
the Filter Pump. Centered position is [OFF].
Digital thermostat ... sets and controls temperature of cooking oil. Pressing
the PROCESS key displays actual oil temperature.
Two (2) electro-mechanical basket timers (right & left), 0 to 30 minute
range.
Light is illuminated whenever the main Power Switch is in the [ON]
position.
Light is illuminated when the Heat Switch is in the [HEAT] position
and the heating elements are energized. This light will cycle ON and
OFF during normal operation as the Controller maintains the set-
point temperature.
Light is illuminated to indicate shutdown of the heating elements
due to excessive heat condition. Should this light turn on during
operation, DISCONTINUE COOKING ACTIVITIES and refer to
Troubleshooting, Section 7. DO NOT ATTEMPT TO CONTINUE
COOKING UNTIL THE CAUSE OF THIS CONDITION IS DETERMINED!
The Drain Open light is illuminated if the cook vat drain valve is not fully
closed. Fryer will not heat if this light is ON.
Illuminates when either, or both, the Grease Baffle Filter or the Charcoal
Filter are not installed, or improperly positioned. Alarm also sounds.
Illuminates to indicate the Basket Timer has expired ... cook cycle
complete ... audible alarm also sounds.
Pressing silences the alert alarm.
In case of an accidental cooking vat fire, pulling this handle will
manually actuate the fire suppression system. Fire system also will
actuate automatically.
The ON Indicator Light is on when the Electronic Air Cleaner (EAC) power
supply is on and operating normally.
The WASH & CHECK Indicator Lights illuminate to indicate an alarm
condition with the EAC system. The EAC Cell is excessively dirty, shorted
out, poor contact, faulty component, etc. Power to heating elements will
be shutdown in approx. 2 minutes after these lights turn ON. DO NOT use
these lights as a signal for routine cleaning ... the cell must be cleaned
DAILY to maintain peak performance.
After the Power Switch is in the [ON] position, press and hold the PUSH-
TO-START Button for 5 seconds to power-up the appliance & hood
(Manual Control ILS Option Only).
GBF Ventless Electric Fryer
GBF-35D & 50D-VH
19