GILES GBF Series Operation & Service Manual page 29

Overview
3.02.1 Control Panel - Computer Controller
Item Description
1 Power Switch
2 Selector Switch
3 Computer Controller
3.1 Function Keys
3.2 Controller Keypad
5 Power Indicator Light (Green)
6 Heat Indicator Light (Amber)
7 High-Limit Indicator (Red)
8 EAC Status [ON]
9 EAC Status [WASH/CHECK]
Fire Extinguisher Manual Pull
10
Function
Main Power Switch ... turns Fryer power ON or OFF.
Selector Switch ... 3-position switch to select operation mode ...
[COOK-OFF-PUMP]. Heating elements only operate when in the
[COOK] position. The switch is placed in the [PUMP] position to run
the Filter Pump. Centered position is [OFF].
Computer Cooking Controller ... set cooking temperature and cook
times ... controls and monitors fryer functions ... displays alarm
conditions and operational prompts. Stores fifty (50) programmable
Menu Item preset cooking times. Features 2 displays ... upper OLED
Display shows errors, alarms, operational prompts & instructions;
lower 7-Segment Display shows cooking values for temp, time, User
settings, etc).
Keys activate various Controller functions.
Enter menu numbers, time & temp values, start & cancel features,
etc. Keys [2], [4], [6] & [8] act as arrow keys for various functions.
Light is illuminated whenever the main Power Switch is in the [ON]
position.
Light is illuminated when the Heat Switch is in the [HEAT] position
and the heating elements are energized. This light will cycle ON and
OFF during normal operation as the Controller maintains the set-
point temperature.
Light is illuminated to indicate shutdown of the heating elements
due to excessive heat condition. Should this light turn on during
operation, DISCONTINUE COOKING ACTIVITIES and refer to
Troubleshooting, Section 7. DO NOT ATTEMPT TO CONTINUE
COOKING UNTIL THE CAUSE OF THIS CONDITION IS DETERMINED!
The ON Indicator Light is on when the Electronic Air Cleaner (EAC)
power supply is on and operating normally.
The WASH & CHECK Indicator Lights illuminate to indicate an alarm
condition with the EAC system. The EAC Cell is excessively dirty,
shorted out, poor contact, faulty component, etc. Power to
heating elements will be shutdown approx. 2 minutes after these
lights turn ON. DO NOT use these lights as a signal for routine
cleaning ... the Cell must be cleaned DAILY to maintain peak
performance.
In case of an accidental cooking vat fire, pulling this handle will
manually actuate the fire suppression system. Fire system also will
Handle
actuate automatically.
GBF Ventless Electric Fryer
GBF-35D & 50D-VH
17