Operation Mode(S); Operation Via Compute Box; Operation Via Ur's Tool Connector - OnRobot SG User Manual

OPERATION MODE(S)

3. Operation Mode(s)
This document covers installation and operation for both:
UR CB3 series robot controllers
•
and UR e-Series robot controllers.
•
Since the two controllers have similar installation and operation screens in these cases only
the e-Series screens are shown. Where the two requires different steps or screens it is
highlighted and referred as:
CB3 series
•
e-Series.
•

3.1. Operation via Compute Box

The product(s) could be used on both UR series via Compute Box, which works with all
products and product combinations. Differnet modes of operation require the same
installation/operation steps. Where the via Compute Box mode requires different steps, it is
highlighted and referred as via Compute Box.

3.2. Operation via UR's Tool Connector

The product(s) could be used on both UR series via via UR's Tool Connector, which works with
the following products and product combinations:
2FG7 or
•
3FG15 (Only on e-Series) or
•
RG2 or
•
RG6 or
•
SG or
•
VG10 or
•
VGC10
•
Differnet modes of operation require the same installation/operation steps. Where the via Tool
Connector mode requires different steps, it is highlighted and referred as via Tool Connector.
10