INVT Goodrive300-01A Series Operation Manual page 7

Goodrive300-01A series VFD for air compressor
1.4.2 Commissioning and running
 Disconnect all power supplies of the VFD before terminal wiring and wait for
 High voltage is present inside the VFD during running. Do not carry out any
 The VFD may start up by itself when P01.21=1. Do not get close to the VFD
 The VFD cannot be used as "Emergency-stop device"
 The VFD cannot be used to brake the motor suddenly. A mechanical brake
Note:
 Do not switch on or off the input power supply of the VFD frequently.
 For VFDs that have been stored for a long time, check and fix the capacitance and try pilot run
first before actual application.
 Close the front cover before running the VFD; otherwise, electric shock may occur.
1.4.3 Maintenance and component replacement
 Only well-trained and qualified professionals are allowed to carry out
 Disconnect all power supplies of the VFD before terminal wiring. Wait for at

Note:

Select proper torque to tighten the screws.

Keep the VFD and its parts and components away from combustible materials during
maintenance and component replacement.

Do not carry out any insulation voltage-endurance test on the VFD or measure the control circuit
of the VFD by megameter.

Take anti-static measures on internal parts during maintenance and component replacement.
1.4.4 Scrap treatment
There are heavy metals in the VFD. Treat with it as industrial effluent.
When the life cycle ends, the product should enter the recycling system. Dispose of
it separately at an appropriate collection point instead of placing it in the normal
waste stream.
at least the designated time after disconnecting the power supply.
operation on the VFD except for keypad setting.
and motor.
device must be installed.
maintenance, inspection, and component replacement of the VFD.
least the time designated on the VFD after disconnecting the power supply.
Take proper measures to prevent screws, cables and other conductive
objects from falling into the VFD during maintenance and component
replacement.
-3-
Safety precautions