INVT Goodrive300-01A Series Operation Manual page 63

Goodrive300-01A series VFD for air compressor
Function
Name
code
sequence state
State of phase
P19.23 sequence detection flat
cable
P20.00 Encoder type selection
Number of PPR (pulse
P20.01 per revolution) of
encoder
P20.02 Encoder direction
Encoder offline
P20.03
detection time
Encoder reverse
P20.04
detection time
Encoder detection filter
P20.05
times
Speed ratio between
P20.06
motor and encoder
Control parameters of
P20.07
synchronous motor
Z pulse offline
P20.08
detection enable
P20.09 Initial angle of Z pulse 0–359.99
Initial angle of
P20.10
magnetic pole
Parameter description
and input phase loss hardware protection,
corresponding fault will be reported when
negative sequence and any phase loss
occurs; otherwise, fault will not be reported.
0: Positive sequence
1: Negative sequence
2: R phase loss
3: S phase loss
4: T phase loss
0: Normal, indicating the flat cable is plugged
in properly
1: Abnormal, indicating the flat cable is not
plugged in
0–1: Reserved
2: Resolver-type encoder
3: Reserved
0–60000 (number of resolver pole pairs*1024)
0: Forward 1: Reverse
0.0–10.0s
0.0–100.0s
Ones: Low speed filter times
Tens: High speed filter times
0–65.535
Bit0: Z pulse calibration enable
Bit1: Encoder angle calibration enable
Bit2: SVC speed measurement enable
Bit3: Resolver speed measurement mode
selection
Setting range: 0x0–0xF
0–1
0–359.99
-59-
Function code description
Default
Modify
value
●
0
◎
2
◎
1024
◎
0
○
0.8s
○
0.8s
○
0x33
○
1.000
○
0x3
○
0
○
0.00
○
0.00