Table of Contents
Advertisement
10.8 CLEANING THE GRATE AND GRATE
SUPPORT
The grate area must be cleaned.
i
Recommended cleaning frequency: refer to the section
"SCHEDULED MAINTENANCE".
Before proceeding to start-up, any unburned pellets
■ ■
which are in the grate must be removed.
Proceed as follows:
- remove the grate deflector(1)
- release the grate (2) from its housing
- remove all ash and any deposits which may have formed, mak-
ing sure that any clogged holes are cleared using an appropri-
ate tool
- keep the "start-up hole" (3) clean
- check the grate support (4) and remove any ash present
- reposition the grate into its original position pushing it towards
the start-up hole
- reposition the grate deflector.
3
a
Before turning on the appliance, check that the grate is
positioned correctly in its seat (and pushed towards the
start-up hole).
A vacuum cleaner which is suitable for use with ash is
■ ■
needed when carrying out this type of cleaning oper-
ation.
i
To dispose of the ash, please refer to the section " DIS-
POSAL OF ASHES ".
PRODUCT INFORMATION, INSTALLATION AND MAINTENANCE
10.9 CLEANING THE COMBUSTION CHAMBER
i
Recommended cleaning frequency: refer to the section
" SCHEDULED MAINTENANCE ".
Proceed as follows:
- remove the grate deflector (1) and remove the grate (2) from
its housing
- remove the upper deflector (3) by lifting it (A) out of its housing
using the grip (4) and extracting it (B) from the front part, while
rotating gently around the side support pins
3
4
1
1
2
2
4
- lift (C) the side deflectors (5) and the rear deflector (6) slightly to
release them from the slots at the bottom (7), moving the lower
part outwards. Then remove them
Fig. 55
DT2003165_H072218EN0_00
A
B
C
5
7
Fig. 56
6
5
7
Fig. 57
35
Advertisement
Table of Contents
