Table of Contents
Advertisement
a
Warning against overfiring:
pellets must not be fed manually into the
■ ■
grate
never add additional fuel by hand
■ ■
do not fill the hopper with any fuels other
■ ■
than wood pellet
the residual pellets in the grate after a failed
■ ■
ignition must be removed before starting a
new ignition process
d
Do not use the appliance as an incinerator or
in any way other than that for which it was de-
signed.
Do not open the door during operation, or op-
■ ■
erate the appliance if the glass is broken.
a
For monitoring and inspection techniques
ensuring heater is operating properly, includ-
ing ensuring visible emissions are minimized,
consult the section " CLEANING AND MAIN-
TENANCE " and " OPERATING INSTRUCTIONS "
(consult the section " MESSAGES - SAFETY
WARNINGS - ANOMALIES ").
Before carrying out any assembly, installation or ignition proce-
dures, the enabled installer must check that the system has been
manufactured in compliance with the applicable instructions
provided by the manufacturer and in compliance with all relevant
regulations. In particular, check:
- suitability of the room where the appliance is to be installed as
well as any restrictions
- the existence of any other appliances
- fresh air intake
- ventilation within the area where the appliance is to be installed
- sufficient clean air flow for combustion: air cannot be taken
from potentially polluted areas
- smoke evacuation system comprising a flue pipe, flue and
chimney.
Installation may also include a series of operations to be carried
out correctly by enabled personnel and for which system com-
patibility must be guaranteed:
- connection to the air intake
- connection to the smoke evacuation system
- ventilation
- assembly and installation
- any necessary electrical or plumbing connections
- insulation
- start-up and operating tests, and where necessary calibration
and adjustment
- cladding and trims
- presentation of additional documentation as prescribed by the
regulations
- end user training by the installer on how to use and maintain
the appliance
- checking and maintenance.
PRODUCT INFORMATION, INSTALLATION AND MAINTENANCE
Other requirements for compliance may be necessary in relation
to specifications required by the appropriate Authorities.
a
DO NOT USE MAKESHIFT COMPROMISES
WHEN INSTALLING THIS APPLIANCE. DAMAGE
AND/OR INJURY MAY RESULT.
2
PRODUCT INFORMATION
2.1
PRODUCT DESCRIPTION
This appliance is:
- a heat generator designed to be run with pellets
- to be used solely for the purpose for which it was designed; all
other uses are to be considered improper and therefore dan-
gerous
- equipped with a smoke evacuation fan which maintains the
pressure in the combustion chamber (vacuum).
The use of a fuel which can be easily transported and stored such
as pellets, facilitates the ease of use of this appliance.
The temperatures, which do not reach excessive levels, together
with the humidifier increase safety of use and give the feeling of a
comfortable, diffused warmth.
A panel on the appliance allows the user to control a wide range
of functions and programming operations.
The pellets are loaded into the hopper manually and the ignition
is electronic.
An electronic control unit controls the pellet dosing into the grate
as well as the flue gas expulsion.
This control unit oversees the correct operation of the appliance
and, thanks to a series of safety devices, signals any faults on the
panel on the appliance itself and if necessary, initiates the appro-
priate procedures.
DT2003165_H072218EN0_00
5
Advertisement
Table of Contents
