Table of Contents
Advertisement
6.8
SECURING TO A WALL
Anchor the appliance to a fixed support, for example a wall, re-
specting the safety distances (refer to the section " MINIMUM
SAFETY DISTANCES ").
Proceed as follows:
- position the appliance in the place where it is to be installed
- mark the position of the wall bracket on the wall (1)
- Move the appliance away from the wall.
- remove the left side panel (2) and the bracket (1)
- position the bracket on the wall
- fix it in correspondence with the struts (3) or a suitable struc-
ture that is able to hold the appliance in place
2
PRODUCT INFORMATION, INSTALLATION AND MAINTENANCE
- reposition the appliance
- fix the bracket to the appliance using the screws removed pre-
viously
- install the left side panel.
1
a
The appliance is equipped with spacers at the rear
Fig. 48
which allow it to rest against a wall.
Before assembling the cladding, make sure that all the screws
have been tightened and that the appliance is secured well.
7
START-UP AND OPERATING TEST
A start-up and operational test must be carried out by a special-
ized qualified technician to check that the appliance and all other
connected system elements operate correctly. It is therefore un-
derstood that depending on whether heating is via air or water,
the hot air ducts present or the hydraulic circuit are to be checked
along with other connected heat sources.
i
Find out the cost of these operations from the special-
ised technician.
Refer to the manual " OPERATING INSTRUCTIONS ".
1
■ ■
4
3
8
CLADDING AND TRIM
When installation has been completed, in addition to the indica-
tions given above, it may be necessary to fit accessories such as
external cladding, parts and trims.
i
Please follow indications provided in the section
" START-UP AND OPERATING TEST ":
Fig. 49
before completing the cladding assembly operations
■ ■
after all cladding and construction interventions have
■ ■
been completed.
DT2003165_H072218EN0_00
Fig. 50
31
Advertisement
Table of Contents
