Table of Contents
Advertisement
5
PREPARATION FOR INSTALLING
5.1
HANDLING
In order to prevent any accidents or damage to the product,
please follow the recommendations below.
- Unpacking and installation must be carried out by at least two
people
- the product must always be moved and handled with suitable
equipment in full compliance with current safety regulations
- the packaged product must be kept in the position according
to the directions shown by the diagrams and signs on the pack
- if ropes, straps or chains are used, ensure that they are able to
take the weight of the pack and that they are in good condition
- use slow continuous movements when moving the pack to
avoid jerking the ropes, chains etc.
- do not tilt the package excessively to avoid toppling
- never stand in the vicinity of loading/unloading equipment
(forklift trucks, cranes etc.).
When handling any steel parts of the cladding it is advisable to
use clean cotton gloves to avoid leaving fingerprints which are
difficult to remove at first time of cleaning.
5.2
UNPACKING
a
Before beginning installation, make sure all the retain-
ers securing the product to the pallet have been re-
moved.
a
When unpacking and removing the packaging materi-
al, make sure the product is not scratched or damaged.
Do not leave parts of the packaging where they are
■ ■
within the reach of children as they could be danger-
ous. Dispose of them according to legislations currently
in force.
Remove the accessories' packaging and any pieces of
■ ■
polystyrene or cardboard used to secure removable
parts, etc. from the firebox and hopper.
a
To make it easier to move the stove during installation
it is recommended that the cladding is removed follow-
ing the indications provided in the paragraph " REMOV-
ING THE CLADDING " and reposition it once installation
has been completed. If you wish to proceed without re-
moving the panels, make sure that while working, the
lower parts of the side panels and the lower front panel
do not get misshapen, scratched or damaged.
PRODUCT INFORMATION, INSTALLATION AND MAINTENANCE
After having removed the material protecting the appliance, re-
move all the retainers securing the appliance to the pallet and
then remove it from the pallet.
6
INSTALLATION
a
All installation, cleaning and maintenance work is to be
carried out when the fire is out, the appliance is cold
and with the power cable of the product itself and/or
any other accessories disconnected.
This work must also be carried out using suitable equip-
■ ■
ment and in full compliance with all health and safety
regulations.
6.1
REMOVING THE CLADDING
If working inside the cladding, remove the side panels as follows:
- remove the top grille (1) by unscrewing the 4 screws (2)
DT2003165_H072218EN0_00
1
2
Fig. 24
Fig. 25
23
Advertisement
Table of Contents
