Table of Contents
Advertisement
a
Connection to the flue must respect minimum safety
distances from heat-sensitive structural components
or inflammable materials (wood panelling, beams or
ceilings, etc) shown in figures.
i
Due to high temperatures, this stove should be placed
out of traffic and away from furniture and draperies.
Children and adults should be alerted to the hazards
■ ■
of high surface temperatures and should stay away to
avoid burn to skin and/or clothing.
Young children should be carefully supervised when
■ ■
they are in the same room as the stove.
Clothing and other flammable materials should not be
■ ■
placed on or near this stove.
a
Certain local code restrictions may apply. Check with
Local Officials first before installing.
In order to ensure safety where there may be the risk of
■ ■
accidental contact with the flue pipe, the external sur-
face must be sufficiently protected in compliance with
regulations and instructions provided by the flue pipe
manufacturer.
a
It is recommended that greater distances than those
indicated above be left all round the stove to make any
necessary work on the appliance easier.
INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT
■ ■
MANUFACTURER.
Most pellet vent pipe requires a minimum of 1" of clear-
■ ■
ance to combustible materials although some can be
installed at 1" clearance.
Certain local code restrictions may apply. Check with
■ ■
Local Officials first before installing.
PRODUCT INFORMATION, INSTALLATION AND MAINTENANCE
4"
10 cm
6"
15 cm
6.2.1 Alcove installation
The clearance to the top of the unit is 59" (150 cm) measured from
the floor.
This is the minimum size we recommend for an alcove with a 59"
ceiling.
DT2003165_H072218EN0_00
0" to BRAKET
see chapter
"SECURING TO A WALL"
SEE VENT
MANUFACTURER'S
INSTRUCTIONS
REAR WALL
APPLIANCE
FLOOR PROTECTION
HEAT
2"
RADIATION
32"
5 cm
AREA
(81cm)
SEE VENT
MANUFACTURER'S
INSTRUCTIONS
DT2033044-1
4"
10 cm
DT2035105-0
Fig. 29
Fig. 30
25
Advertisement
Table of Contents
