Performing A Final Check-Out After Installation; Checking The Cabinet After Setup; Powering Up The Mts - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

6802800U74-AN
Chapter 4: Hardware Installation
Port 2 D-Type 25
Pin
2
14
1
For more information on alarm wiring, see
page 155.
4.12

Performing a Final Check-Out after Installation

Perform the following procedure after the completion of the MTS installation. This final check-out
procedure ensures the proper operation of the MTS.
Process:
1 Perform the Cabinet final check-out.
See Checking the Cabinet after Setup on page
2 Power-up the MTS and the Expansion Cabinet.
See Powering Up the MTS on page
4.12.1

Checking the Cabinet after Setup

Procedure:
1 Switch to OFF the Power Supply Unit.
2 Verify that the connections on all modules and on the junction panel are secure. Make any
necessary adjustments.
3 Installations with a backup battery only: Check if the wires on plus (+) and minus (-) poles
are securely connected.
4 Installations with a temperature sensor: Check that the temperature sensor is attached.
4.12.2

Powering Up the MTS

CAUTION: Power-up procedure is arranged to prevent MTS damage in case of an equipment
or installation defect.
Procedure:
1 Ensure the switch on the Power Supply Unit is switched OFF before proceeding.
2 Check the connections at Power Supply Unit.
3 Installation with the battery backup only: Check the connections at the backup battery.
4 Set the switch to ON.
NOTICE: The Power Supply Unit automatically recognizes a connected backup battery
and begins charging, in operation or at start up.
5 Watch the Power Supply Unit LED indicators to monitor the PSU inputs and outputs during the
startup procedure.
14
0
External Alarm 4
External Alarm 3
External Alarm 2
User Alarms/Controls, X.21, RGPS, and GPS Cabling on
140.
Description
140.