Configuring Redundant Site Controller - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

6802800U74-AN
Chapter 15: Expansion Options
8 Connect the Ethernet cables previously attached to the Base Radio(s) to the Site Controller.
Also connect the newly added Site Controller to the junction panel according to the scheme
below:
Part no
3066543B10
3066560B01
3066567B02
9 Connect RF cable 3066543B10 to GPS connector.
10 Connect the redundant control signal cable according to the scheme below:
Part no
3066544B17
3066544B17
NOTICE: Make sure to follow the color indications on both the cables as well as on the
Site CONTROLLER.
11 Remove the Terminator from the CAN2 output on the Power Supply Unit and connect the CAN
Bus cable according to the scheme below:
Part no
3066544B03
12 Connect the power cables to the MTS Power Supply Units.
15.4.2

Configuring Redundant Site Controller

NOTICE: Redundant Site Controller feature is supported by MTS Software releases:
• MTS SPU R5.2_002.34 or later
• MTS SPU R6.0_001.12 or later
NOTICE: On power up of the Standby Site Controller the Base Radios may dekey and reset.
Base Radios will automatically recover and key up again within 20 seconds.
Process:
1 Perform Site Controller Hardware Pre-Checks.
See Performing Site Controller Hardware Pre-Checks on page
2 Configure the Site Controller Configuration Files.
See Configuring Site Controller Configuration Files on page
3 Configure Ethernet ports connecting the two Site Controllers.
See Configuring Ethernet Ports on page
4 Configure the ID values of the Site Controllers.
See Configuring Site Controller IDs on page
434
Cable type From
RF Cable Junction Panel / E1
Y splitter
Y splitter
Cable type From
Redundant CTRL SC1 / RedIn
signal cable
Redundant CTRL
SC1 / RedOut
signal cable
Cable type From
CAN Bus cable SC2 / CAN
435.
436.
To
Y splitter
SC1 / E1
SC2 / E1
To
SC2 / RedOut
SC2 / RedIn
To
PSU2 / CAN2
435.
435.