Configuring Site Controller Ids - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

6802800U74-AN
Chapter 15: Expansion Options
• eth0: 10.0.254.2
• eth1: 10.0.253.2
NOTICE: For an MTS using a single Site Controller, the Ethernet settings should be checked
using the ifconfig -a command from the SC application prompt. From the output, confirm
that the eth0 and eth1 ports are configured as expected. See Procedure below for more
information on how to set SC IDs.
Procedure:
1 Log onto Boot1 of the Site Controller during startup.
2 From the prompt, run the command spr inet/if/eth0.
3 From the prompt, run the command spr inet/if/eth1.
4 Take note of the IP addresses and the MAC addresses.
NOTICE: If the IP addresses are set correctly (as stated in lists before this procedure),
continue to Step 8 below.
NOTICE: If the IP addresses are set incorrectly, they must be changed as follows in the
next step.
5 Log onto Boot1 of the Site Controller.
6 From the prompt, run the command
spw inet/if/eth0 "dhcp:no addr:10.0.253.X mask:255.255.255.0
dev_name:tsec dev_unit:0 ethaddr:yy:yy:yy:yy:yy:yy mtu:1500"
NOTICE:
X = 1 for SC1, and 2 for SC2
•
• yy:yy:yy:yy:yy:yy = the MAC address of the interface. Note that eth0 and eth1 have
different MAC addresses.
7 From the prompt, run the command
spw inet/if/eth1 "dhcp:no addr:10.0.254.X mask:255.255.255.0
dev_name:tsec1 dev_unit:1 ethaddr:yy:yy:yy:yy:yy:yy mtu:1500"
NOTICE:
• X = 1 for SC1, and 2 for SC2
• yy:yy:yy:yy:yy:yy = the MAC address of the interface. Note that eth0 and eth1 have different
MAC addresses.
8 IMPORTANT: Remember to check the IP settings on both SCs.
15.4.2.4

Configuring Site Controller IDs

NOTICE: The Site Controllers must have different ID values configured. To check the SC id,
follow the steps below.
Procedure:
1 Log onto the Site Controller Application MMI.
2 From the SC: prompt, run the command id.
436