Connecting The Backup Battery Sensor To The Equipment Cabinet; Figure 45: Backup Battery Sensor Connections On Mts 4 Junction Panel; Figure 46: Backup Battery Sensor Connections On Expansion Cabinet Junction Panel - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

6802800U74-AN
Chapter 4: Hardware Installation

Figure 45: Backup Battery Sensor Connections on MTS 4 Junction Panel

Figure 46: Backup Battery Sensor Connections on Expansion Cabinet Junction Panel

4.5.3.6

Connecting the Backup Battery Sensor to the Equipment Cabinet

WARNING: Make sure all power to the Power Supply Unit is off to prevent accidental contact
with high energy and injury to personnel.
NOTICE: Ensure that all the battery temperature sensor cables are fitted into the battery
associated with the appropriate PSUs.
CAUTION: The MTS station is to be connected only to those backup batteries, which are in
accordance with the applicable electrical codes for the end use country.
NOTICE: Backup battery systems are not manufactured by Motorola Solutions. Consult the
manufacturer's instruction manual and other pertinent documentation for installing a battery
systems. Any local regulations shall be adhered to when installing the battery equipment.
Procedure:
1 Plug the temperature sensor cable (Motorola P/N 0166501N84) into the 2-pin connector on one
side and attach the sensor to the backup battery according to the manufacturers instructions,
which are supplied with the accessory kit. See the following figure.
10
8