Connecting Ethernet Site Link Retrofit Kit For Mts 2 (Old Jp); Connecting Ethernet Site Link Retrofit Kit For Mts 2 (New Jp); Connecting Ethernet Site Link Retrofit Kit For Mts 4 - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

6802800U74-AN
Chapter 4: Hardware Installation
4.10.1.1

Connecting Ethernet Site Link Retrofit Kit for MTS 2 (old JP)

When and where to use:
Follow this procedure to gain Ethernet Site Link functionality from the E1 connector on the previous
type of MTS 2 Junction Panel.
Procedure:
1 Remove existing E1 cable from the E1 connector on Junction Panel.
2 Connect the open E1 connector on the Junction Panel with the RJ45 coupler (3066562B01).
3 Connect the Ethernet Y Splitter (01015002001) to the lose end of the RJ45 coupler connected in
previous step.
4 Connect the Link1 and Link2 outputs on the Ethernet Y Splitter to the Site Controller by using
the Ethernet cables as described in
and Figure 101: Ethernet Site Link Cabling for MTS 2 on page
4.10.1.2

Connecting Ethernet Site Link Retrofit Kit for MTS 2 (new JP)

Procedure:
1 Bend open and connect the open Link1 connector on the Junction Panel with the RJ45 coupler
(3066562B01).
2 Bend open and connect the open Link2 connector on the Junction Panel with the RJ45 coupler
(3066562B01).
3 Connect the Link1 and Link2 outputs on the Ethernet Y Splitter to the Site Controller by using
the Ethernet cables as described in
and Figure 101: Ethernet Site Link Cabling for MTS 2 on page
4.10.1.3

Connecting Ethernet Site Link Retrofit Kit for MTS 4

Unlike the MTS 2, the previous type of MTS 4 Junction Panel has an unused AUX breakout which will
be used, together with the existing E1 connector, for Ethernet Site Link functionality.
When and where to use:
Follow this procedure to gain Ethernet Site Link functionality from the E1 and AUX connectors on the
previous type of MTS 4 Junction Panel.
Procedure:
1 Remove existing E1 cable from E1 connector on Junction Panel.
2 Connect the open E1 connector on the Junction Panel with the RJ45 coupler (3066562B01).
3 Bend AUX breakout and insert the second RJ45 coupler (3066562B01).
4 Attach remaining cables.
• For configurations with single Site Controller, follow
MTS 4 with Single Site Controller on page 169
MTS 4 with Single Site Controller on page 171
• For configurations with dual Site Controller, follow
MTS 4 with Dual Site Controller on page 172
MTS 4 with Dual Site Controller on page 173
13
6
Table 45: Ethernet Site Link Cabling for MTS 2 on page 168
Table 45: Ethernet Site Link Cabling for MTS 2 on page 168
Table 46: Ethernet Site Link Cabling for
and Figure 102: Ethernet Site Link Cabling for
for further cabling and connections.
Table 47: Ethernet Site Link Cabling for
and Figure 103: Ethernet Site Link Cabling for
for further cabling and connections.
169.
169.