Cavity Combiner - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

7.3.5.1.4
Updating the Mapping List with the New Unit TrackID
Procedure:
1 Log on to the Site Controller.
2 View the mapping list by entering: can check_mapping.
Step example:
Units are present:
Device Track ID
DPM 1 JTH0500101
PSU 1 JTH0500200
Units are not present:
DPM 2 JTH0500105
Track ID not mapped:
JTH0500102
3 On the mapping list, locate the removed unit indicated as Units are not present.
4 Delete the old CAN Bus unit from the CAN Bus unit mapping list by entering: can
remove_mapping <X>.
<X> identifies the old unit name and is digit between 0 and 3.
Step example: can remove_mapping dpm 2.
5 Add the new CAN Bus unit to the CAN Bus unit mapping list by entering: add_mapping
dpm<X><track ID>.
<track ID> is a Track ID of the new unit.
<X> identifies the new unit name and is a digit between 0 and 3.
NOTICE: The new unit Track ID is present on the replaced unit label and indicated as
Track ID not mapped.
Step example: can add_mapping dpm 2 JTH0500102
6 View the updated mapping list by entering: can check_mapping.
7 On the mapping list, check that there are no units labeled as Track ID not mapped or
Units are not present.
7.3.6

Cavity Combiner

NOTICE: MTS 2 does not support Cavity Combiners.
There are two types of Cavity Combiners available:
• Auto Tune Cavity Combiners (ATCC)
• Manual Tune Cavity Combiners (MTCC)
MTCCs are functionally the same as ATCCs except that they are tuned manually instead of
electronically.
NOTICE: 260 MHz configurations does not support MTCC.
Chapter 7: Radio Frequency Distribution System
6802800U74-AN
283