Figure 117: Holes In Top Lid For Rx Cables; Table 63: Tx Atcc Phasing Harness Part Numbers - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

Cable
In-
Part
dex
Number
bers on
page 188
18 See Table ATCC (3, 4)
63: TX
ATCC
Phasing
Harness
Part Num-
bers on
page 199
19 3066543B RX Splitter 1 /
11 Prime Cab
20 3066543B RX Splitter 2 /
11 Prime Cab
RX Splitter 3 /
21 3066543B
11 Prime Cab
NOTICE:
In the Prime Cabinet, detach the Duplexer Tx cable in the prime cabinet from the T connector
on the Interconnect Harness in the prime. Connect the free end of the Phasing Harness from
the expansion cabinet to the T connector on the Interconnect Harness in the prime cabinet and
connect the Duplexer Tx cable to the T connector in the Phasing Harness. This way all eight
channels are connected to a single Duplexer.
When Manual Tune Cavity Combiner (MTCC) is used instead of Auto Tune Cavity Combiner
(ATCC), connect the cables to corresponding inputs and outputs.
RX cables from Filters in Prime Cabinet to RX Splitters in the Expansion Cabinet are routed
through holes on the back side of the top-lid.

Figure 117: Holes in Top Lid for Rx Cables

Table 63: TX ATCC Phasing Harness Part Numbers

Part Number Description
0166502N09 Phasing harness,
8Ch
From Unit To Unit
ATCC (1, 2)
Prime Cabinet
Duplexer /
Exp Cab (in
MTS 4 Prime
Cabinet)
Preselector
1 / Exp Cab
(in MTS 4
Prime Cabi-
net)
Preselector
2 / Exp Cab
(in MTS 4
Prime Cabi-
net)
Frequency Band
361 MHz – 366 MHz
Chapter 5: Interconnection and Internal Cabling
TX path, Phasing Harness rout-
ed through conjunction hole at
side of cabinet
RX path/ RX on 1 or 2 ant.
RX path/ RX on 1 or 2 ant.
RX path/ RX on 2 ant.
Holes in Top lid for connecting
Filters in Prime Cabinet to RX
Splitters in Expansion Cabinet
6802800U74-AN
Notes
199