Expanding From Mts 2 To Mts 4; Extracting The Module Cage From Mts 2 - Motorola MTS LiTE Installation, Configuration And Basic Service Manual

15.7.1

Expanding from MTS 2 to MTS 4

Follow the process below to extract the Module Cage from MTS 2 and assemble it into the expanding
MTS 4 Cabinet.
Process:
1 Extract the Module Cage from MTS 2, see
441.
2 Assemble the Module Cage in the MTS 4 cabinet, see
4 Cabinet on page 443
15.7.1.1

Extracting the Module Cage from MTS 2

Procedure:
1 Remove all RF cables (RX, TX, and GPS if mounted).
2 Disconnect all cables between the module cage and the Junction Panel.
3 Remove any CAN Bus cables going to and from the Filter(s).
4 Remove the filter section by:
• Removing 6 pcs. M4 screws using TORX20.
• Remove the special Ground screw using a normal screw driver.
NOTICE: Filter modules need to be removed in order to have access.
NOTICE: The Ground screw should be reattached after removal of the filter section.
Extracting the Module Cage from MTS 2 on page
Assembling the Module Cage in the MTS
6802800U74-AN
Chapter 15: Expansion Options
441