Danfoss VFD500 Series Manual page 91

Chapter 5 Function code
P23.25 Fault source for auto reset
P23.26 Fault auto Reset times
Numberic output Action at
P23.27
fault reset
Interval time of fault auto
P23.28
Fault auto reset times
P23.29
clearing time
Continuing Running
P23.30 frequency selection when
Abnormal back-up
P23.31
frequency
Motor overload protection
P24.00
gain
Motor overload starting
P24.01
current at zero speed
Motor overload starting
P24.02
current at Rated speed
VFD500 high performance vector control frequency inverter user manual
Define as per bit:
bit0-overcurrent during acceleration;bit1-
overcurrent during deceleration
bit2-overcurrent during constant speed;bit3-over
voltage during acceleration
bit4-overvoltage during deceleratoin;bit5-
overvoltage during
bit6-inverter undervoltage;bit7-input phase loss
bit8-inverter overload;bit9-inverter overheat
bit10-motor overload;bit11-motor overheat
bit12-user'fault 1;bit13-user'fault 2
bit14-Reserved;bit15-Reserved
0～99
0:Disabled
1:Enabled
0.1s～300.0s
reset
0.1s～3600.0s
0：Run at current frequency
1：Run at setted frequency
2：Run at upper limite frequency
trip
3：Run at lower limit frequency
4：Run at abnormal back-up frequency
0.0%～100.0%(maximum frequency )
24 Group motor Protection parameter
0.20～10.00
The larger the value, the longer the allowable
overload operation, and the higher the risk of
motor overheating damage.
50.0%～150.0%
50.0%～150.0%
88
☆
0
☆
0
☆
0
☆
0.5s
☆
10.0s
0 ☆
☆
5.0%
☆
1.00
☆
100.0%
115.0%
☆