Danfoss VFD500 Series Manual page 43

Chapter 4 Operation and display
start
Follow the instructions in Chapter 3 to install the inverter and wire it
Make sure the power cable , motor cable and brake unit are connected
Observe the safety precautions and switch on the power supply
Set each parameter in turn according to the
guidance of the wizard , set the motor self -
learning mode P 11.10, press the run b utton,
waiting for the complete of self -learning
Open control
Y
• Press RUN to Run inverter
• Press STOP
While monitoring the output frequency
or command frequency ,press
ENTER to modify the target
frequency
!
VFD500 high performance vector control frequency inverter user manual
correctly
Enter guide mode -GdE-
N
to stop inverter
End
4-3Trial run flow chart
close loop vector control (VC),Before normal
operation , ensure that the encoder P 10.03 is in
the correct directionIf rotary self -learning is
performed , the encoder orientation can be
automatically recognized and storedIf it is not
executed , it needs to open the loop control to
run the motor and observe whether the encoder
feedback (r10.12) is in the same direction with
the given direction , if no,change as P 10.03
40