Danfoss VFD500 Series Manual page 48

VFD500 high performance vector control frequency inverter user manual
Function Parameter name
code
Action when set
P01.10 frequency lower than
lower limit frequency
Delay time when set
P01.11 frequency lower than
lower limit frequency
Jump frequency start
P01.12
up protection
Jump frequency 1 lower
P01.13
limit
Jump frequency upper
P01.14
limit
Jump frequency 2 lower
P01.15
limit
Jump frequency 2
P01.16
upper limit
Jump frequency 3 lower
P01.17
limit
Jump frequency 3
P01.18
upper limit
Description
0：Run at low limit frequency
1：Stop after delaying P01.11
2：Run at zero speed
The inverter will coast to stop when the set
frequency is lower than the lower-limit one.if
the set frequency is above the lower limit one
again and it lasts for the time set byP01.11, the
inverter will come back to the running state
automatically.
0.000s～30.000s
This function code determines the hibernation
delay time. When the running frequency of the
inverter is lower than the lower limit one, the
inverter will stop to stand by.
When the set frequency is above the lower limit
one again and it lasts for the time set by
P01.11, the inverter will run automatically.
!
Unit/ten/hundred'digit：three jump frequency
1/2/3
0：Disable
1：Enable (avoid risk speed)
0.00Hz～(P01.14)
P01.13- (P01.06)Maximum frequency
0.00Hz～(P01.16)
P01.15～maximum frequency(P01.06)
0.00Hz～(P01.18)
P01.17～maximum frequency(P01.06)
45
Chapter 5 function code table
Default Property
★
0
★
0.000s
☆
000
0.00Hz ☆
0.00Hz
☆
☆
0.00Hz
☆
0.00Hz
☆
0.00Hz
☆
0.00Hz