Danfoss VFD500 Series Manual page 66

VFD500 high performance vector control frequency inverter user manual
Digital input termimal
P06.30 filtering time
Terminal protection
P06.31
function
P06.32 DI terminal on/ready time
P06.33 VDI1 source
P06.34 VDI 2 source
P06.35 VDI 3 source
P06.36 VDI 4 source
r07.00 DO output port status
DO1 Output terminal
P07.01
function group
DO2(HDO) Output terminal
P07.02
function group
0.000～0.100s
Set the sample filter time of DI1~DI4 and HDI
terminals. If the interference is strong, increase
the parameter to avoid wrong operation.
0：no protection
When command is terminal ,power on and
terminal effective,inverter will run
1：protection
When command is terminal ,power on and
terminal effective, inverter will not run ,so need
terminal ineffective then effective,then inverter
will run
0.000s～30.000s
To Select the source of VDI1, Please select the
input signal of VDI1 together with the Unit's digit
of P06.17.
To Select the source of VDI2, Please select the
input signal of VDI1 together with the Ten's digit
of P06.17.
To Select the source of VDI3, Please select the
input signal of VDI1 together with the Hundred's
digit of P06.17.
To Select the source of VDI4, Please select the
input signal of VDI1 together with the Thousand's
digit of P06.17.
07 Group Multi-function Digital output
Define as per bit,
0:ineffective 1:effective
Bit0:DO1 Bit1:D02 Bit2:relay1, Bit 3:relay 2 Bit4:
DO3;Bit5: DO4 Bit6: DO5; Bit7: DO6
Bit8: VDO1;Bit9: VDO2
0:No function
1:READY
2:RUN
3:Error1（stop fault）
4:Error2（same as Error1 except undervoltage）
63
Chapter 5 function code table
☆
0.010s
0 ★
★
1.000s
06.00
★
★
06.00
★
07.00
★
44.00
- ●
☆
0
☆
0