Changing Joint Bearing In Articulated Unit - Husqvarna P524 Workshop Manual

Chassis

5.1.6 Changing joint bearing in articulated unit

1. Control stay
2. Joint bearing in
articulated unit
3. Steering cylinder
4. Link stay
Tools
Combination wrench
Combination wrench
Combination wrench
Combination wrench
Combination wrench
Combination wrench
Combination wrench
Combination wrench
Combination wrench
Circlip pliers
Chisel
Torque wrench
Fine threaded torque
wrench
24 – English
4
1
3
2
Dimension
13 mm
15 mm
16 mm
22 mm
27 mm
32 mm
15 mm
17 mm
19 mm
SGH
17 mm
WARNING!
Never insert hands or fingers as
heavy components are unstably
supported. Use tools that reach.
Risk of crush injuries.
Check of joint bearing in
articulated unit
Check the condition of the joint bearing in the
articulated unit by measuring the distance between
the joint bearing and the bolt fastener.
1. Make sure there is a clear gap between the link
stay and the screw head on the engine belt
pulley.
If the distance between the pulley and the screw
head reduces, the joint bearing must be changed.