Reparation instructions
Checking and adjusting freewheel
clutch Rider 850/970
1
The freewheel clutch is correctly adjusted when the
tensioning wheel's outward movement is stopped
by the belt and not by the wire.
2
There should be a play (A) of 8-10 mm between
the wire nipple and the lever.
3
2
3
1
Adjust the freewheel clutch wire as follows:
• Pull off the rubber sleeve (1). Loosen the nuts
(2) and stretch the wire with the adjuster screw
(3).
• Tighten the lock nuts (2) after adjustment.
22
– English
Replacing articulated steering bearing
1
• Remove the engine according to the earlier
description (see page 12).
• Block up the ride-on mower in front of the
articulated steering.
2
6
A
• Release the tensioning wheel spring (1).
• Release the clutch, gear and brake wire (2, 3
and 4) and remove the wires' holder plates (5
and 6).
5
4
3
2
1