Brake Cable - Husqvarna P524 Workshop Manual

5.1.3 Brake cable

Checking the brake cable
Tools
Combination wrench
Torx
Snipe nose pliers
Torque wrench
Check that the parking brake is adjusted correctly
by placing the machine on a slope.
• Apply the parking brake.
The parking brake must be adjusted if the machine
is not stationary.
If the machine does not stay still once the parking
brake has been adjusted, the parking brake cable
must be replaced.
Replacing brake cable
1. Remove the cover over the frame tunnel.
2. Remove the left wing cover.
3. Remove the rubber cover from the brake cable.
4. Remove the E-clip.
Dimension
5. Pull back the rubber protection so that the cable
13 mm
T 30
6. Loosen the recoil spring from the pedal arm.
7. Make a note of how the brake cable is routed.
8. Pull back the rubber protection so that the cable
9. Loosen the recoil spring going to the brake arm.
10. Remove the cable from the brake lever arm.
Assembling
Assemble in reverse order. The parking brake cable
must be checked and possible adjusted once fitted.
can pass through the bracket opening.
can pass through the bracket opening.
Chassis
English – 19