Husqvarna P524 Workshop Manual page 33

Propulsion
10. Loosen the oil cooler and set aside.
11. Unplug the electrical connector for the magnetic
clutch.
12. Remove the torque stop of the magnetic clutch.
13. Remove the hydraulic pump drive belt, see
section "5.6.10 Replacing pump belt" on page 69.
14. Remove the PTO belt. For further instructions,
refer to "5.6.11 Changing the PTO belt" on
page 71.
32 – English
15. Remove the cover protecting the pump drive
belt in order to access the front engine
mounting.
16. Remove the engine mountings, two each side,
and lift up the engine from the machine with the
engine pulley and magnetic clutch.
Assembling
Assemble the engine in reverse order.
NB!
Hold the battery cable screws in place so that
the electrodes are not strained.