Delivery And Service; Service Schedule - Husqvarna P524 Workshop Manual

2.1 Service schedule

Key
The following is a list of maintenance procedures that must be performed on the ride-on mower. Most points
not described in this workshop manual can be found in the operator's manual.
Not described in this workshop manual or operator's manual.
n
Described in this workshop manual.
m
Described in the operator's manual.
Care
Clean under the cutting deck
Clean and lubricate the belt
tensioner bearings.
Clean around the muffler
Clean thoroughly around the engine
Clean thoroughly around the
transmission
Clean the frame tunnel
Clean the air filter
Clean the cooling fins on the engine
and hydrostatic transmission
Clean the combustion chamber
Check the engine cooling air intake
Check the fuel pump's air filter
Check/adjust the parking brake
Check the safety system
Check nuts and bolts
Check for fuel and oil leakages
Check the oil level in the
transmission and top up if
necessary (SAE 10W/50)
Check the cutting deck bolts for the
belt pulleys, blades, etc.
Check that the hydraulic hoses and
couplings are clean and undam-
aged.
Check/adjust front and rear wheel
rotation speed
Check the engine's maximum
speed (3,0000rpm).
Check the air pressure in the tires
100 kPa / 1.0 bar / 14.5 PSI
Check the fuel hose. Replace if
necessary.
Check that the pump belt tension
is correct
Check that the RTO belt tension is
correct

2 Delivery and service

Chapter Daily Daily
mainte- mainte-
nance nance
before after
m
5.1.3
n
5.3.5 n
2.2 n
5.2.10
3.1
After Weekly At
1)
the mainte- least
first 25 nance once
hours a year
m
n
Delivery and service
Maintenance
interval in hours
40 100 200 400
m m m
n n n
n
m m m
English – 5