Husqvarna P524 Workshop Manual page 78

9. Release the belt from the tool frame.
10. Lower the tool frame by removing its rear lead
screws. In order to release the tool frame on
the left side completely it must first be pulled
back.
11. Release spring tension fully.
12. Unhook the springs.
13. Pull the tool frame forwards.
Assembling
1. Slide in the tool frame. Make sure that the
height adjustment stay is inserted into the
equipment frame.
2. Hook the springs onto the tool frame.
3. Reassemble the tool frame in reverse order.
4. Reinsert the lifting chain and lock it with the
stay so that one chain link is visible.
5. Tension the springs and assemble the cutting
deck.
6. Check and if necessary adjust the ground
pressure, see section "5.7.8 Checking and
adjusting ground pressure" on page 82.
Cutting system
English – 77