Husqvarna P524 Workshop Manual page 32

Dismantling the motor
1. Remove the engine cover. For more
information, refer to "5.2.1 Dismantling the
engine cover" on page 29.
2. Remove the battery, see section "5.3.3 Battery"
on page 44.
NB!
Hold the battery cable screws in place so that
the electrodes are not strained.
3. Remove the cable between the starter relay and
the starter from the starter.
4. Mark and remove the engine's electrical
connectors.
5. Remove the clips holding the throttle and choke
cables. Unhook the cables from their
attachments on the carburettor casing.
6. Remove the hose clamp on the fuel hose by the
fuel pump and pull the fuel hose downwards.
Suspend the hose to stop fuel leaking.
7. Loosen the heat plate over the muffler, two
screws on each side, and remove the plate.
8. Loosen the exhaust clamps at the muffler.
9. Remove the screws from the muffler and lift off
the muffler.
Propulsion
English – 31