Battery; Fuses - Husqvarna P524 Workshop Manual

Electrical system

5.3.3 Battery

Tools
Combination wrench x2
Dismantling
1. Open the engine hood.
2. Loosen the battery fastening strap.
3. Remove battery cable connections.
a. Always dismantle the NEGATIVE terminal
first.
b. Then dismantle the POSITIVE terminal.
4. Remove the battery.
Assembling
Assemble in reverse order.
1. Place the battery in the battery compartment.
2. Assemble the battery cable connections.
b. Always assemble the POSITIVE terminal
first.
c. Then assemble the NEGATIVE terminal.
3. Secure the battery with the retaining strap.
4. Close the engine cover.
44 – English

5.3.4 Fuses

The main fuse is placed in a detachable holder
Dimension
under the battery.
10 mm
Type: Flat pin, 20 A.
Do not use any other fuse when changing.
Remaining fuses are under the right side cover.
The fuses are connected to protect the following
circuits:
FU1 = PTO
FU2 = Oil cooler blower
FU3 = 12V socket
FU4 = Headlight
Type: Flat pin, 5 A.
Use 20 A fuses when changing.
A blown fuse is indicated by a burnt link. Pull the fuse
from the holder when replacing it.
The fuse is intended to protect the electrical system.
If it blows again shortly after replacement, it is due to
a short circuit, which must be fixed before the
machine can be put into operation again.