Checking And Adjusting Throttle; Replacing Articulated Steering Bearing - Husqvarna Rider 111 B Workshop Manual

Checking and adjusting throttle

Rider 111 B
1 Remove the protective cover.
3
4
1
2 Detach the locking nut (1) on the ball joint.
3 Remove the locking spring (2) so that the ball
socket (3) can be removed from the ball on the
lever arm (4).
4 Press the forward accelerator pedal down
completely and move the lever arm (4) forwards
as far as possible.
5 Adjust the position of the spherical socket (3) on
the connecting rod (5) so that it just fi ts over the
pivot on the lever. Fit the spherical socket on the
pivot.
6 Lock the setting with the lock nut (1) and press
the locking spring (2) into position.
IMPORTANT INFORMATION
Check that the locking spring goes
through the hole in the spherical socket.
5
2

Replacing articulated steering bearing

1 Remove the engine cover by loosening two
snap-in locks at the front and two hinges at the
back edge of the engine cover.
2 Remove the side cover on the left hand side of
the front carriage. One screw at the side and one
at the top, under the seat.
3 Remove the rear cover of the front carriage.
Reparation instructions
25
English –