Husqvarna P524 Workshop Manual page 62

13. Slide in the bearing unit.
14. Remove the screw (4).
4
15. Dismantle the transmission by removing the
retaining screws.
16. Take the transmission out of the casting.
17. If the transmission is being changed, the
devices for adjusting the wheel speed (1) and
adjustment screw for the slewing speed (2)
must be transferred to the new transmission as
below:
1
1. Wheel speed
adjustment
2. Slewing speed
adjustment screw
13
12
11
10
8
9
18. Dismantle the device for the slewing speed
adjustment screw by removing the screw (1)
and nut (6). Note the position of the spring (4)
and washer (5).
19. Dismantle the link head (3) with nut (2).
20. Dismantle the device for adjusting the wheel
speed (13) by removing nut (12) and screw (8).
21. Dismantle the plates (10) only if any measures
need to be taken (e.g. cleaning).
22. If the transmission is being changed, dismantle
the hydraulic connection adapters for reuse.
Hydraulic system
2
4 3
3. Link head
4. Screw
1. Screw
2. Nut
3. Link head
1
4. Spring
7
5. Washer
6. Nut
7. Nut
8. Screw
9. Link head
10. Plate
2
11. Bushing
3
12. Nut
4
13. Wheel speed
5
adjuster
6
English – 61