Husqvarna P524 Workshop Manual page 80

Attaching the cutting deck
1. Place the machine on a flat surface and apply
the parking brake. Check that the lever for
setting the cutting height is in its lowest, service,
position.
2. Push the equipment frame down and place the
catch against the frame.
3. Push the deck in and put the front guide plugs in
the grooves on the equipment frame, one on
each side.
4. Push the unit in so that the interior plugs touch
the bottom of the equipment frame's grooves.
5. Place the cutting deck belt around the cutting
deck drive wheel and hook on the height
adjustment cable.
6. Secure the springs on the tension pulley.
7. Fit the front cover.
Removing the cutting deck
1. Put the cutting deck in the service position up to
and including "lifting the cutting deck drive belt",
see Service position for cutting deck.
2. Raise the cutting deck lock.
3. Pull out the cutting deck.
WARNING!
Take care not to trap your hand
Cutting system
English – 79