Transmission Oil Change; Hydraulic Oil Change - Husqvarna P524 Workshop Manual

Propulsion

5.2.4 Transmission oil change

Tools
Torx
Allen Key
Flat-blade screwdriver
Observe cleanliness. Follow the directions in section
"5.6.1 Hydraulic hygiene" on page 52.
Transmission capacity is 0.9 liters (0.9 US qt) fully
synthetic engine oil SAE 10W/50 in the respective
gearbox Make it easier to change oil by warming up
the engine before draining the oil.
Rear axle
1. Place a vessel under the rear transmission.
2. Remove the rear transmission cover.
3. Loosen the bottom plug and allow the oil to drain
into the vessel.
4. Clean thoroughly around the filler.
5. Open the filler cap.
6. Refit the drain plug.
7. Top up with the new oil.
8. There is always a small amount of oil remaining
in the transmission after draining it. Therefore,
always use a dipstick to make sure the oil level is
correct.
Front axle
1. Remove the left wing cover.
2. Place a vessel under the front transmission.
3. Loosen the drain plug and allow the oil to drain
into the vessel.
34 – English
4. Clean thoroughly around the filler.
Dimension
5. Open the filler cap.
T30
10 mm
6. Refit the drain plug.
7. Top up with the new oil.
8. There is always a small amount of oil remaining

5.2.5 Hydraulic oil change

Hydraulic tank capacity is 8 liters (8.5 US qt) fully
synthetic engine oil SAE 10W/50.
1. Remove the side cover.
2. Dismantle the right wing cover.
3. Remove the protecting cover protecting the right
4. Place a vessel under the hydraulic tank drain
5. Loosen the plug and allow the oil to drain into the
6. There is always a small amount of oil remaining
in the transmission after draining it. Therefore,
always use a dipstick to make sure the oil level
is correct.
side of the machine.
plug.
vessel.
in the hydraulic tank after draining it. Therefore,
always use a dipstick to make sure the oil level is
correct.