Usage (Emulator Debugger); Starting Up The Emulator Debugger (Init Dialog Box) - Renesas Emulation Probe M30850T2-EPB User Manual

M30850T2-EPB User's Manual

3. Usage (Emulator Debugger)

This chapter describes how to start up the emulator debugger and how to use the major windows, taking the M3T-PD308F as
an example. The following can apply to the M32C PC7501 emulator debugger.

3.1 Starting Up the Emulator Debugger (Init Dialog Box)

To launch the emulator debugger, click the Start menu of Windows and then select
Program (P) >> [RENESAS-TOOLS] >> [PD308F V.xx.xx Release x] >> [PD308F].
When the emulator debugger started up, the Init dialog box appears.
(1) MCU tab
1. Specifying the MCU file
Cancel
2. Specifying the communication interface (LPT communication)
Cancel
REJ10J1005-0200 Rev.2.00 April 1, 2007
Help
Help
3. Usage (How to Use the Emulator Debugger)
Specifying the MCU file
Click the "Refer..." button.
A file selection dialog box will be displayed, so select the
desired MCU file. The MCU file is stored in the directory in
which you installed the M3T-PD308F.
(Example: c:\mtool\PD308F\mcufiles)
- The MCU file contains the information specific to the
target MCU.
- The MCU file you have selected is displayed in the MCU
section of the MCU tab.
Specifying the communication interface
(LPT communication)
For selecting the LPT communication, click the radio button
"LPT" of the MCU tab. Specify the using LPT
communication mode at the Type area. Specify the I/O
address of the parallel port at the I/O address area. For BIOS
setup, the following addresses are available.
- 378h
- 278h
Page 46 of 98