Table of Contents
Advertisement
M3028BT-EPB User's Manual
3. Usage (Emulator Debugger)
This chapter describes how to start up the emulator debugger and how to use the major windows.
3.1 Starting Up the Emulator Debugger
When debugging the completed programs, switch the session. The session can be changed by the drop down list of the tool bar
shown below.
You will have as many sessions created as the number of targets you selected when creating a project, so select the session that
corresponds to the target to be connected from the drop-down list. To connect to the PC7501 and M16C/Tiny emulation probe,
select "SessionM16C_R8C_PC7501_Emulator."
3.1.1 INIT Dialog Box
After specifying the session, an Init dialog box to connect the target is displayed. The Init dialog box is used to set the items
that need to be set when the emulator debugger starts up. The contents set in this dialog box remain effective the next time you
start the debugger.
When the tab settings of (1) to (4) are completed, click OK button.
(1) MCU tab
1. Specifying the MCU file
REJ10J1459-0200 Rev.2.00 Sep 16, 2006
3. Usage (Emulator Debugger)
Specifying the MCU file
1. Click the "Refer..." button.
2. A file selection dialog box will be displayed, so select the
desired MCU file.
- The MCU file contains the information specific to the
target MCU.
- The MCU file you have selected is displayed in the MCU
section of the MCU tab.
Page 42 of 86
Advertisement
Table of Contents
