Turning The Power On - Yamaha MO6 Owner's Manual

Turning the power on

Make sure the volume settings of the MO and external devices are turned down to the minimum.
Turn the power on by pressing the [STANDBY/ON] switch on the MO rear panel, then turn the power on the
amplifiers.
Connecting MIDI devices or a Mixer
Make sure that all volume settings are turned down all the way to the minimum. Then turn on the every
device in your setup in the order of MIDI masters (controllers), MIDI slaves (receivers), then audio
equipment (mixers, amplifiers, speakers, etc.).
When powering down the setup, first turn down the volume of each audio device, then switch off each
device in the reverse order (first audio devices, then MIDI).
Adjusting the sound and the display contrast
Adjust the volume levels of the MO and the connected amplifier/speaker system. If the display is not easily
visible, use the Contrast control to adjust for optimum visibility.
Now that you've set up the MO properly, you're ready to begin playing it.
n
When you are ready to turn off the MO, make sure to switch off the power of the external device (or lower its volume)
before switching off the MO.
1
MIDI master
Adjust the volume with the Adjust the display contrast
MASTER VOLUME slider. with the Contrast control.
MASTER
VOLUME
MASTER
VOLUME
2
POWER
ON!!
MO (MIDI slave)
SF1
F1
Contrast control
Power supply
3
Audio equipment
(first mixer, then amplifier)
Owner's Manual 21