Yamaha MO6 Owner's Manual page 126

Creating Your Original Program Set (Master mode)
Assigning Control Change numbers to the Knobs/Sliders for each Zone
Here in the KN/CS display of the Master Edit mode, you can set how the Control Knobs and Sliders will affect each Zone.
This lets you specify a separate MIDI Control Change number for each Knob and Slider.
All indicators are turned off by setting the
[MASTER]
Knob/Slider parameter to "zone."
In the example above, the Control Knobs for all Zones have been set to 10 (Pan), and the Sliders have been set to 11
(Expression). In this way, you can control the stereo position of each Zone with the appropriate Knob, and use the Sliders to
adjust the relative volume balance among the Zones.
126 Owner's Manual
[EDIT] [COMMON] [F2] OTHER
DAW REMOTE PAGE SELECT
ASSIGN A ASSIGN B
PAN SEND
PAN REVERB
CUTOFF RESONANCE
ASSIGN
SWING GATE TIME
TONE
LOW LOW MID
ARP FX
MEF
EQ
MASTER ZONE 1 ZONE 2
VOLUME
You can determine which Control Change numbers are used
for the Knobs and Sliders for each zone in the [MASTER]
[EDIT] Zone selection [F5] KN/CS display.
ASSIGN 1 ASSIGN 2
CHORUS TEMPO
ATTACK RELEASE
VELOCITY UNIT MULTIPLY
HIGH MID HIGH
ZONE 3 ZONE 4