Yamaha MO6 Owner's Manual page 75

Press the [PATTERN] button to enter the
6
Pattern mode.
MODE
VOICE
SONG
DAW
REMOTE
EDIT
COMPARE
Press the [F] (Play) button to start Pattern
7
playback.
There is another way to start Pattern playback—by
pressing the notes on the keyboard. Move the cursor to the
keyboard icon and press the [INC/YES] button so that the
mark appears. In this status, press any key to start the
Pattern playback.
Try out various rhythm variations by changing
8
the Section.
Make sure that the [SECTION] lamp is on (press the button
if necessary), then press any of the buttons shown below to
select and play the various Sections contained in a Pattern.
Pressing the [A] – [H] buttons calls up Sections A – H and
pressing the [PRE1] – [–] buttons calls up Sections I – P.
PRE 1 PRE 2 PRE 3 PRE 4 USER 1
A. PIANO KEYBOARD ORGAN GUITAR BASS
PLUCKED
A B C D
SYN LEAD SYN PAD SYN COMP CHROMATIC DRUM
CHOIR PERCUSSION PERCUSSION
n
Some Sections of the Demo Pattern may have no data. Because of
this, selecting some Sections may result in no sound.
Press the [J] (Stop) button to stop Pattern
9
playback.
Unlike Song playback, Pattern playback continues in a
loop until the [J] (Stop) button is pressed.
You can stop the Pattern anytime during playback by
pressing the [J] (Stop) button. This pauses the Pattern at
the current position. To resume playback of the Pattern
from that point, press the [F] (Play) button again. To
instantly return to the beginning of the Pattern, press the
[ I E] (Top) button.
PERFORM MASTER
PATTERN MIXING
FILE UTILITY
DEMO
JOB STORE
SCENE STORE
SET LOCATE
USER 2 GM –
SECTION
STRINGS BRASS REED PIPE
E F G H
SE MUSICAL FX COMBI
10
Select and play another Demo Pattern.
Selecting a Pattern is done in the same way as selecting a
Song. Refer to step 5 above.
Using Mute/Solo with the Song and
Pattern tracks
Try this with the Demo Songs to hear how the tracks sound
both in isolation and in various combinations.
To mute a track
1
Press the [MUTE] button (the lamp lights).
Press any of the NUMBER [1] – [16] buttons to
2
select the track number to be muted.
The corresponding track is set to mute (its lamp goes off)
and produces no sound. When pressing the same number
button again, the track mute is canceled (its lamp lights).
1 2 3 4
ELEMENT PERF. PART ZONE
9 10 11 12
To turn Mute off, press the [MUTE] button again (the lamp
goes off).
To solo a track
Simultaneously hold down the [MUTE] button and press
one of the Number buttons [1] to [16] to solo the
corresponding track. Once you've selected a track for
soloing, the [MUTE] button's lamp flashes, indicating the
Solo function is active.
While Solo is active, you can change the soloed track
simply by pressing the corresponding Number button [1] to
[16]. To cancel the Solo function, press the [MUTE] button
again.
1 2 3 4
ELEMENT PERF. PART ZONE
9 10 11 12
Playing the Demo Songs/Patterns
TRACK
5 6 7 8 SELECT
13 14 15 16 MUTE
SOLO
TRACK
5 6 7 8 SELECT
13 14 15 16 MUTE
SOLO
Owner's Manual 75