Table of Contents
Advertisement
Setting Up
Using Batteries
This instrument accepts AA alkaline batteries and rechargeable Ni-MH (Nickel-Metal Hydride) batteries.
1.
Make sure that the power of the instrument is off.
2.
Turn the instrument over and place it on a soft cloth.
Open the battery compartment cover located on the
instrument's bottom panel.
3.
Insert six new batteries. Make sure that they are
orientated correctly according to the illustration.
4.
Close the battery compartment with the cover.
NOTICE
• Do not connect or disconnect the DC plug of the AC adaptor while the
power is on, even if the batteries are installed. Doing so, the power will
suddenly turned off and this result in the loss of data being recorded
or transferred at the time.
• When battery power becomes low, a message saying "Low Battery"
will appear on the screen. When this happens, either replace or
recharge all batteries. If you continue to use the instrument in this
condition, it may not work properly, or the power will suddenly and
automatically turn off because of insufficient power.
NOTE
• Use only the specified charger device for charging rechargeable batteries.
This instrument cannot be used to recharge batteries.
• Power will be automatically drawn from the AC adaptor when an AC
adaptor is connected even if batteries are installed in the instrument.
Turning the Power On/Off
Turning the Power On
1.
Move the [MAIN VOL] slider to the left to
reduce the volume to the minimum setting.
2.
If necessary, connect any external devices
(amplifiers for digital instrument, etc.) to
the instrument.
For details on how to connect these devices, refer
to "Connecting External Devices" (page 32).
3.
Press the [P] (Standby/On) switch to turn
the power on.
The screen on the instrument will appear.
4.
Turn the power on to any external devices,
and then adjust the volume and other
settings on the external device.
5.
Adjust the volume on the instrument.
5-1.
Center the [BALANCE] slider.
5-2.
Gradually shift the [MAIN VOL] slider to the right to raise the volume while playing the
keyboard.
NOTICE
Do not attempt to use the instrument (press any keys or buttons, or step on pedals, etc.) after turning on the power until the
instrument has completely started up (the Home screen appears). Doing so may cause the instrument to malfunction.
14
HD-300 Owner's Manual
Battery compartment cover
Bottom of the instrument
Advertisement
Table of Contents
